My father took advantage of my new pantograph NC asking me to make a plate for a display of belts. I must say that the wood used is very good and suitable for this type of 3D processing, hard enough without overdoing.
The finish has been achieved by using a couple of coats of primer solvent stain cherry waiting 24 hours between coats. I gave then a sanded with fine to remove residual stain and then 3 coats of natural wax of bees and much "elbow grease". This is the result ...
The finish has been achieved by using a couple of coats of primer solvent stain cherry waiting 24 hours between coats. I gave then a sanded with fine to remove residual stain and then 3 coats of natural wax of bees and much "elbow grease". This is the result ...
0 comments:
Post a Comment